Compression Molding is completely transparent
A detailed view into the mold
On K 2022, SIGMA Engineering presents the new version 6.0 of SIGMASOFT® Virtual Molding. Besides the reworked intuitive user interface one highlight is the introduction of simulative Compression Molding. It allows to zoom into the production process in every location, anytime and in any cycle. Examples include the thermal influence of the open mold, during preparation and while preforms are positioned – or to analyze plastification and curing of the elastomer in detail.
Aachen, 25.08.2022 – During K 2022 in Duesseldorf (October 19-26th 2022) SIGMA Engineering GmbH presents the evolution of SIGMASOFT® at booth 13-B29. The new version 6.0 has a completely fresh user interface and besides other new features now also contains the possibility to analyze the traditional Compression Molding of elastomers.
Until now, simulative mold and process design were limited mainly to modern injection molding technology. SIGMASOFT® has already been utilized successfully by leading elastomers processors, and their desire to also simulate the older processes was voiced many times. The industrial significance of Compression and Transfer Molding remains high, as safety and precision parts are also manufactured using these processes. The use of high-quality materials makes a better process understanding and in advance optimization through simulation even more desirable. The simulation also allows for a secure evaluation of curing degree and process-cycle data. Issues such as the quantity, shape, weight, and position of the preforms can also be optimized easily. This allows to improve the quality of the molded parts while reducing the material usage - without cumbersome and costly series of trials. In SIGMASOFT®, all thermal influences on the component and in the mold, from the smallest screw to the energy loss of the mold over several cycles, can be viewed in detail during the simulation of compression molding. This makes thermal optimizations or improvements on cycle time easy.
“It sounds easy, but implementation was quite complex”, explains SIGMA CTO Timo Gebauer: “The challenge is, that the cavity, or the room where we otherwise inject into, constantly changes during the closing of the mold. At the same time, the inserted preforms are already heating up, and are plasticizing and deforming. This development would not have passed the finish line without continuous advice and validation through our customers.”